Removal and Installation
WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the flywheel dowels by using a drift pin where the flywheel dowel is installed in an open hole and a pair of locking pliers where the flywheel dowel is installed in a blind hole.
- Install all flywheel dowels by driving them into place using a brass or plastic mallet.
NOTE:
Take care not to damage the flywheel dowel holes or the surface areas around the flywheel dowel during removal.
NOTE:
Care should be taken to drive the flywheel dowel squarely into place until it is fully seated and to make sure the surrounding surface areas are not damaged.