LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 474 (Automatic Transmission) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Shift Concerns: No First Gear in Manual First Position - 216/316

Shift Concerns: No First Gear in Manual First Position - 216/316

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
SHIFT CONCERNS: NO FIRST GEAR IN MANUAL FIRST POSITION - 216/316

Possible Component Reference/Action
216 - ELECTRICAL ROUTINE 
Powertrain Control System 
  • Electrical inputs/outputs, vehicle wiring harnesses, internal transmission wiring harness, PCM, SSA and SSB
  • Carry out shift point road test. Run on-board diagnostic. REFER to the INTRODUCTION - CNG, FLEX-FUEL & GASOLINE article for diagnosis. Carry out pinpoint tests using the diagnostic tool. Repair as required. Clear DTCs, road test and rerun Self-Test.
316 - HYDRAULIC/MECHANICAL ROUTINE 
Incorrect Pressures 
  • Incorrect band/clutch application pressures (no engine braking), line pressure low
  • Check line pressure at tap. Carry out line pressure and stall speed tests. Refer to the LINE PRESSURE CHART  for specifications. If pressure is low, check the following possible component: main control.
Main Control Assembly 
  • Screw out of torque specification
  • Tighten to specification.
  • Gasket damaged, off location
  • Inspect and install a new gasket.
  • Separator plate damaged
  • Inspect for damage. Repair as required.
  • SSA and SSB solenoid stuck, damaged, O-ring damaged or out of bore
  • Inspect for damage. Carry out solenoid function test as listed in electrical routine. Repair as required.
  • Inspect for damage. Repair as required.
  • Check ball A damaged
  • Inspect for damage. Carry out solenoid function test as listed in electrical routine. Repair as required.
Reverse Band 
  • Burnt, damaged
  • Inspect for damage. Repair as required.
  • Servo piston, seals, gasket or cover damaged
  • Inspect and install new piston, seals or gasket as required.
Reverse Drum 
  • One way clutch damaged
  • Inspect for damage. Repair as required.
  • Bearing damaged
  • Inspect for damage. Repair as required.
  • Drum damaged
  • Inspect for damage. Repair as required.
Low/Reverse One-Way Clutch Assembly 
  • Rear one-way clutch damaged
  • Inspect for damage. Repair as required.