LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 473 (Electronic Engine Control System) >> Removal And Installation >> Clutch Pedal Position (CPP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the electrical connector from the clutch pedal position (CPP) switch.
    Fig 1: Disconnecting CPP Switch
    G03275366Courtesy of FORD MOTOR CO.
  3. Spread the CPP switch apart. Remove from the pedal rod.
    Fig 2: Removing CPP Switch From Pedal Rod
    G03275367Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals