Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Remove the left front inner fenderwell splash shield.

Fig 1: Removing Left Front Inner Fenderwell Splash Shield
Courtesy of FORD MOTOR CO.
Disconnect the coolant bypass hose from the routing clip.

Fig 2: Disconnecting Coolant Bypass Hose From Routing Clip
Courtesy of FORD MOTOR CO.
Gently pry the positive crankcase ventilation (PCV) valve cap off the two tabs.

Fig 3: Removing PCV Valve Cap
Courtesy of FORD MOTOR CO.
Remove the PCV valve from the crankcase vent oil separator and disconnect the vacuum hose.

Fig 4: Removing PCV Valve And Disconnecting Vacuum Hose
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.