LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 463 (Engine - 4.0L SOHC) >> In-Vehicle Repair >> Timing Drive Components - Hydraulic Chain Tensioner, LH >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. For additional information, refer to INTAKE MANIFOLD .
  2. Remove the thermostat housing. For additional information, refer to ENGINE COOLING .
  3. Remove the LH camshaft tensioner.
    Fig 1: Removing LH Camshaft Tensioner
    G03274462Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals