General Specifications - Cylinder Block
WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS - CYLINDER BLOCK
| Item | Specification |
|---|---|
| Head Gasket Surface Flatness Head Gasket Surface Finish (RMS) |
0.08 mm (0.003 in.) in 152.0 mm (6.00 in.) 1.0 - 3.3 Micrometers |
| Cylinder Bore | |
| Diameter Surface Finish (RMS) |
89.00 mm (3.504 in.) 0.45 - 0.96 |
| Out-of-Round Limit | 0.025 mm (0.001 in.) |
| Out-of-Round Service Limit | 0.050 mm (0.002 in.) |
| Taper Service Limit Main Bearing Bore Diameter |
0.050 mm (0.002 in.) 68.905 mm (2.713 in.) 68.885 mm (2.712 in.) |