LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 462 (Engine - 3.0L (2V)) >> In-Vehicle Repair >> Exhaust Manifold RH >> Removal

Exhaust Manifold RH: Removal

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Remove the exhaust flange nuts.
    Fig 1: Removing Exhaust Flange Nuts
    G03274079Courtesy of FORD MOTOR CO.
  4. Remove the exhaust manifold bolts and stud bolts.
    Fig 2: Removing Exhaust Manifold Bolts And Stud Bolts
    G03274080Courtesy of FORD MOTOR CO.
  5. Remove the exhaust manifold gasket and the exhaust manifold.
scientia non olet · About LEMON Manuals