Brake Drums
WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Manual adjustment of the rear brake drum assemblies should only be done when the rear brake pads are replaced, new drums are installed, or existing drums are machined. If the rear brake drum assembly is not adjusted correctly, brake drag, grab, lock, overheating, and fade may occur. For additional information, refer to DISC & DRUM
article.
- Remove the brake drum. For additional information, refer to DISC & DRUM article.
- Inspect the brake drum and measure the brake drum inside diameter in a minimum of 4 places around the circumference of the brake drum. Record the measurements.
- Install new brake drum if any diameter measurement is greater than the maximum specification. Refer to SPECIFICATIONS .
- Install new brake drum if cracked. For additional information, refer to DISC & DRUM article.
- Heavily scored brake drums, similar to that caused by shoes worn down to the backing plate, should be machined. In order to machine, drums must be below the maximum diameter specification. Refer to SPECIFICATIONS .