LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 450 (Rear Drive Axle/Differential - Ford 7.5" Ring Gear) >> In-Vehicle Repair >> Drive Pinion Seal >> Removal

Drive Pinion Seal: Removal

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the pinion flange. For additional information, refer to DRIVE PINION FLANGE .
  2. Pry up on the metal flange of the rear axle drive pinion seal. Install gripping pliers and strike with a hammer until the rear axle drive pinion seal is removed.
    Fig 1: Removing Pinion Seal
    G03272231Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals