LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 441 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Rear Door Handle >> Material

Rear Door Handle: Material

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL

Item Specification
Multi-Purpose Grease Spray F5AZ-19G209-AA ESR-M1C159-A
  1. Remove the rear door trim panel. For additional information, refer to INTERIOR TRIM - LS .
  2. To remove the individual components, only carry out the listed steps.
    COMPONENT STEPS SPECIFICATION

    Component Step
    Exterior door handle 1-3
    Rear door latch 1,4-7
    Interior door handle 1,4-9
  3. Remove the components in the order indicated in the following illustration and table.
    Fig 1: Identifying Exterior Rear Door Handle Actuating Rod
    G03203955Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.

Item 8: Interior Rear Door Handle Rivets Installation Note 

  1. Use the special tool to install the new rivets.
    Fig 2: Using Special Tool To Installing New Rivets
    G03203956Courtesy of FORD MOTOR CO.