Memory Seat

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

Memory seat positioning can be recalled with the memory switches on the driver door panel or a programmed remote keyless entry transmitter. In either case, the DSM receives a memory recall 1 or 2 command from the driver door module (DDM) over the SCP communication network. The memory recall switches are a hardwired input to the DDM. The DDM also receives the remote keyless entry transmitter signals. Once a valid memory recall command is received from the DDM, the DSM moves the driver seat to the position stored in memory by powering the appropriate motors and monitoring the motor position sensors until the position is reached.

This system allows automatic positioning of the driver seat to two programmable positions.

To program position one, move the driver seat to the desired position using the seat control switch. Depress the set button. Within five seconds, depress button one.
To program position two, repeat the previous procedure using the set button and button two.
To recall position one, depress button one. To recall position two, depress button two.

A position can only be recalled when the transmission selector is in PARK or NEUTRAL. A position may be programmed at any time.