Before Pinpoint Tests

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Prior to entering pinpoint tests, check the powertrain control module (PCM) wiring harness for correct connections, bent or broken pins, corrosion, loose wires, correct routing, correct seals and their condition. Check the PCM, sensors and actuators for damage. Refer to the INTRODUCTION article for diagnosis and testing of the powertrain control system.

NOTE: If a concern still exists after electrical diagnosis, refer to DIAGNOSIS BY SYMPTOM in this section.

If DTCs appear while carrying out the on-board diagnostics, refer to the DIAGNOSTIC TROUBLE CODE CHARTS in this section for the appropriate repair procedure. Prior to entering pinpoint tests, refer to any TSBs and OASIS messages for transmission concerns.