LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 425 (Intake Air, Fuel Charging, Starting & Engine Electronics - 3.9L) >> Removal And Installation >> Mass Air Flow (MAF) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable.
  2. Remove the components in the order indicated in the following illustration and table.
  3. To install, reverse the removal procedure.
    Fig 1: Removing Mass Air Flow (MAF) Sensor
    G03201561Courtesy of FORD MOTOR CO.