LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 423 (Engine Cooling) >> Removal And Installation >> Coolant Outlet Pipe - 3.0L (4V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this section.
  2. Remove the air cleaner outlet tube. For additional information, refer to INTAKE AIR, FUEL CHARGING, STARTING & ENGINE ELECTRONICS - 3.0L (4V) .
  3. Remove the components in the order indicated in the following illustration and table. See Fig 1.
    Fig 1: Coolant Inlet Pipe - 3.0L (4V) Removal Sequence
    G03201436Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
  5. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this section.
scientia non olet · About LEMON Manuals