Removal & Installation (Front)
WARNING: This page is about a different car, the 1999 Mercury Mystique, 1999 Mercury Cougar, 1999 Ford Contour, 1998 Mercury Mystique, and 1998 Ford Contour. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect negative battery cable. Raise and support vehicle. Remove wheel. Remove sensor retaining bolt and remove sensor from vehicle. Remove wiring harness from support brackets. Remove front fender splash shields. Disconnect wheel sensor electrical connector. To install, reverse removal procedure. Ensure wiring is routed properly. Tighten sensor bolt to specification. See TORQUE SPECIFICATIONS .