LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 392 (Engine Cooling System) >> Diagnosis & Testing >> Component Tests >> Cap

Component Tests: Cap

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the radiator cap or degas bottle cap and seals for damage or deterioration. Install a new radiator cap (8100) or degas bottle cap (8101) if necessary.
  2. Fit the radiator cap to the Radiator/Heater Core Pressure Tester Kit using the aftermarket adapter.
    3. NOTE: If the plunger of the pressure tester is depressed too fast, an incorrect pressure reading will result.
  3. Slowly pump the pressure tester until the pressure gauge stops increasing and note the highest pressure reading. Release the pressure and repeat the test. Install a new radiator cap if the pressure is not 99.3-121.4 kPa (14.4-17.6 psi).
scientia non olet · About LEMON Manuals