LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 391 (Engine System -- General Information - Ranger) >> General Procedures >> Cylinder Bore - Out-Of-Round

Cylinder Bore - Out-Of-Round

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the cylinder bore in two directions. The difference is the out-of-round. Verify the out-of-round is within the wear limit and bore the cylinder to the next oversize limit.
    • Refer to appropriate ENGINE article for the procedure.
    Fig 1: Measuring Cylinder Bore Out-Of-Round
    G03435298Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals