LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 391 (Engine System -- General Information - Ranger) >> General Procedures >> Connecting Rod - Twist

Connecting Rod - Twist

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the connecting rod twist on a suitable alignment fixture. Follow the instructions of the fixture manufacturer. Verify the measurement is within specification.
    • Refer to appropriate ENGINE article for the procedure.
    • If out of specification, install new components as necessary. Refer to appropriate ENGINE article for the procedure.
    Fig 1: Measuring Connecting Rod Twist On Alignment Fixture
    G03435316Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals