LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 391 (Engine System -- General Information - Ranger) >> General Procedures >> Connecting Rod - Large End Bore

Connecting Rod - Large End Bore

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Tighten the bolts to specification, then measure the bore in two directions. The difference is the connecting rod bore out-of-round. Verify the out-of-round is within specification.
    • Refer to appropriate ENGINE article for the procedure.
    • If out of specification, install new components as necessary. Refer to appropriate ENGINE article for the procedure.
    Fig 1: Measuring Connecting Rod - Large End Bore Diameter
    G03435313Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals