Axle Assembly - Front: Installation
WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse the removal procedure.
- Fill the front axle with the correct type and quantity of lubricant.
- Install new driveshaft bolts and straps.
- Install new axle mounting bolts.
CAUTION:
Install a new retainer circlip on the left inboard CV joint housing. If reinstalling the original axle housing, install a new retainer circlip on the right side.
CAUTION:
Make sure the halfshaft circlips fully seat.