Axle Tube Bearing: Installation

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Use the Axle Bearing Replacer and the Handle to replace the RH axle tube bearing.

Fig 1: Installing RH Axle Tube Bearing
Courtesy of FORD MOTOR CO.
Check the bearing depth as shown.

Fig 2: Checking Bearing Depth
Courtesy of FORD MOTOR CO.
Use the Axle Seal Replacer and the Handle to replace the axle tube seal.

Fig 3: Installing Axle Tube Seal
Courtesy of FORD MOTOR CO.

CAUTION: Care should be taken not to damage the axle seal surface.

Fig 4: Installing Axle Shaft

Courtesy of FORD MOTOR CO.

Install the axle shaft.
Refill the front drive axle to proper level with lubricant.
Install the RH halfshaft. For additional information, refer to AXLE SHAFTS (4WD) .