LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 384 (Rear Drive Axle/Differential 8.8-Inch Ring Gear) >> In-Vehicle Repair >> Rear Wheel Bearing & Axle Shaft Oil Seal >> Removal

Rear Wheel Bearing & Axle Shaft Oil Seal: Removal

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the axle shaft (4234). For additional information, refer to AXLE SHAFT .
    2. NOTE: If only a new seal needs to be installed, use care to avoid damaging the seal bore.
    NOTE: If the wheel bearing oil seal (1177) is leaking, the differential housing vent may be plugged with foreign material.
  2. Using a suitable seal remover, remove the axle shaft oil seal. Discard the oil seal.
  3. Inspect the rear wheel bearing and axle shaft for wear or damage.
  4. Using the special tools, remove the rear wheel bearing.
    Fig 1: Removing Rear Wheel Bearing
    G03434442Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals