LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 377 (Automatic Transmission - 4R100) >> Disassembly And Assembly Of Subassemblies >> Output Shaft - Check Gas Engine >> Assembly

Output Shaft - Check Gas Engine: Assembly

WARNING: This page is about a different car, the 2002 Ford RV Cutaway, 2002 Ford Econoline, 2002 Ford E550 Super Duty, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If any damage is found to the output shaft drive sprocket speed sensor wheel, a new output shaft drive sprocket speed sensor wheel will need to be installed.
    Fig 1: Installing Park Gear
    G01963227Courtesy of FORD MOTOR CO.
  1. If removed, use the arbor press and the special tool to install the park gear, press the park gear onto the output shaft until it stops at the shoulder on the output shaft.
  2. If removed, install the output shaft drive sprocket speed sensor wheel using the special tool.
    Fig 2: Installing Output Shaft Drive Sprocket Speed Sensor Wheel Using Special Tool
    G01963228Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals