LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 375 (Engine System - General Information) >> General Procedures >> Cylinder Bore - Out-of-Round

Cylinder Bore - Out-of-Round

WARNING: This page is about a different car, the 2002 Ford Econoline, 2002 Ford E550 Super Duty, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the cylinder bore in two directions. The difference is the out-of-round. Verify the out-of-round is within the wear limit and bore the cylinder to the next oversize limit.
    • Refer to the appropriate ENGINE article for the procedure.
      Fig 1: Measuring Cylinder Bore - Out-Of-Round)
      G03404791Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals