Brake Pads
WARNING: This page is about a different car, the 2002 Ford RV Cutaway, 2002 Ford Econoline, 2002 Ford E550 Super Duty, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
It is not required to install new brake pads if friction material properties are within guidelines. It is also not required to install new brake pads when the brake discs are machined.
- Remove the brake pads. For additional information, refer to DISC & DRUM .
- Inspect and measure the thickness of the brake pad friction material.
- Install new brake pads if the thickness of the friction material is less than 3.0mm (0.118 in). For additional information, refer to DISC & DRUM .
- Compare all four front or rear pads for uneven wear. Install new brake pads if the thickness of the friction material varies from pad to pad by more than 2.0mm (0.079 in). For additional information, refer to DISC & DRUM .
- Install new brake pads if there are missing chunks or cracks in the lining through to the backing plate. For additional information, refer to DISC & DRUM .
- If the friction material shows taper wear (i.e. the thickness varies by more than 3.0mm [0.118 in] in any direction) verify the caliper guide pins are functioning correctly. For additional information, refer to BRAKE CALIPER GUIDE PINS .