LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 364 (Driveline System - General Information) >> Diagnosis And Testing >> Driveline System >> Analysis of Vibration >> Pilot Runout - Semi-Floating Axle

Pilot Runout - Semi-Floating Axle

WARNING: This page is about a different car, the 2002 Ford RV Cutaway, 2002 Ford Econoline, 2002 Ford E550 Super Duty, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the Dial Indicator Gauge with Holding Fixture with the Clutch Housing Gauge to the pilot, as close to the axle flange face as possible. Zero the indicator to allow the pointer to deflect either way.
    Fig 1: Measuring Pilot Runout - Semi-Floating Axle
    G03404599Courtesy of FORD MOTOR CO.
  2. Rotate the flange one full turn and note the maximum and minimum readings. The difference between the maximum and minimum readings will be the total pilot runout. Pilot runout must not exceed 0.076 mm (0.003 inch).
scientia non olet · About LEMON Manuals