LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 356 (Engine System-General Information) >> General Procedures >> Valve - Seat Inspection >> Valve And Seat Refacing Measurements

Valve And Seat Refacing Measurements

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: After grinding valves or valve seats, check valve clearance.
  1. Check the valve head and seat.
    • Check valve angles.
    • Check margin width.
    • For 2.0L Zetec engine procedure see appropriate section in ENGINE - 2.0L ZETEC . For 3.0L (4V) engine procedure see appropriate section in ENGINE - 3.0L (4V) .
    • Be sure margin width is within specification.
    Fig 1: Checking Valve Angles And Margin Width
    G03429583Courtesy of FORD MOTOR CO.
  2. Inspect for abnormalities on the valve face and seat.
scientia non olet · About LEMON Manuals