LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 356 (Engine System-General Information) >> General Procedures >> Camshaft Journal - Clearance, Plastigage Method >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Special Tool(s)
G03429523Courtesy of FORD MOTOR CO.
NOTE: The camshaft journals must meet specifications before checking camshaft journal clearance.
  1. Remove the camshaft bearing cap and lay Plastigage across the surface. For 2.0L Zetec engine procedure see appropriate section in ENGINE - 2.0L ZETEC . For 3.0L (4V) engine procedure see appropriate section in ENGINE - 3.0L (4V) .
    2. NOTE: Do not turn the camshaft while carrying out this procedure.
    Fig 2: Positioning Camshaft Bearing Cap
    G03429524Courtesy of FORD MOTOR CO.
  2. Position the camshaft bearing cap and install the bolts. For 2.0L Zetec engine procedure see appropriate section in ENGINE - 2.0L ZETEC . For 3.0L (4V) engine procedure see appropriate section in ENGINE - 3.0L (4V) .
  3. Use Plastigage to verify the camshaft journal clearance.
    • If out of specification, install new components as necessary. For 2.0L Zetec engine procedure see appropriate section in ENGINE - 2.0L ZETEC . For 3.0L (4V) engine procedure see appropriate section in ENGINE - 3.0L (4V) .
scientia non olet · About LEMON Manuals