Removal and Installation

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch to the unlock position.
Remove the tire and wheel assembly.
Remove the castellated nut.
1. Remove the cotter pin.
2. Remove the castellated nut.
Fig 1: Removing Castellated Nut
Courtesy of FORD MOTOR CO.
Loosen the tie rod end jam nut.

Fig 2: Loosening Tie Rod End Jam Nut
Courtesy of FORD MOTOR CO.
Using the special tool, separate the tie rod end.

Fig 3: Separating Tie Rod End
Courtesy of FORD MOTOR CO.
Remove the tie rod end.

Fig 4: Removing Tie Rod End
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Adjust the front toe. For additional information, refer to SPECIFICATION & PROCEDURES .