LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 347 (Safety Belt System) >> General Procedures >> Safety Belt With Anchor Plate Thread Damage

Safety Belt With Anchor Plate Thread Damage

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the broken or stripped bolt and discard.
  2. Drill out the internal threads in the seat belt anchor plate with a 27/64-inch drill.
  3. Rethread the anchor plate with a 1/2-13 tap (seat belt).
  4. Blow out the chips.
  5. Install the safety belt component(s).
  6. Install a new bolt with the same part number, unless otherwise specified.
  7. Tighten the bolt(s) to specification. For additional information, refer to TORQUE SPECIFICATIONS  .
scientia non olet · About LEMON Manuals