LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 346 (Wiper System And Washer System) >> General Procedures >> Wiper Blade and Pivot Arm Adjustment

Wiper Blade and Pivot Arm Adjustment

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Cycle and park the windshield wipers.
  2. Verify that the distance between the center of the RH windshield wiper blade (17528) and the cowl top vent panel is within specification.
    Fig 1: Verifying Right Wiper Blade Position
    G01441793Courtesy of FORD MOTOR CO.
  3. Verify that the distance between the center of the LH windshield wiper blade and the cowl top vent panel is within specification.
    Fig 2: Verifying Left Wiper Blade Position
    G01441794Courtesy of FORD MOTOR CO.
  4. If the distance is not within specification, remove the windshield wiper pivot arm (17526) that is not within specification and reposition it to specification; refer to PIVOT ARM .
scientia non olet · About LEMON Manuals