LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 341 (Interior Trim And Ornamentation) >> Removal And Installation >> A-Pillar Trim Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Right side shown, left side similar
  1. Remove the right front assist handle covers.
    Fig 1: Removing Right Front Assist Handle Covers
    G01440872Courtesy of FORD MOTOR CO.
  2. Remove the assist handle bolts.
    Fig 2: Removing Assist Handle Bolts
    G01440873Courtesy of FORD MOTOR CO.
  3. Remove the assist handle.
  4. NOTE: Pull down at the top of the A-pillar trim panel to release upper retaining clip
    Fig 3: Removing A-Pillar Trim Panel
    G01440874Courtesy of FORD MOTOR CO.
  5. Pull the A-pillar trim panel downward to release the remaining two retaining clips.
  6. To install, reverse the removal procedure.