LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Engine Controls - Theory & Operation - Gasoline & NGV) >> Miscellaneous Controls >> Pcm Controlled Charging System >> Generator Load

Generator Load

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2002 Mercury Sable, 2002 Mercury Mountaineer, 2002 Mercury Grand Marquis, 2002 Mercury Cougar, and 2002 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

Generator Load Input (GLI) circuit is used by PCM to determine generator load on engine. As generator load increases, PCM will adjust idle speed accordingly. This helps reduce idle surges due to switching high current loads. GLI signal is sent to PCM from voltage regulator/generator. GLI signal is a variable frequency duty cycle. Normal operating frequency is 40-250 Hz. Normal signal DC voltage (referenced to ground) is between 1.5 volts (low generator load) and 10.5 volts (high generator load).

scientia non olet · About LEMON Manuals