LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 323 (Engine Cooling) >> Removal And Installation >> Block Heater - 7.3L Diesel >> Removal

Block Heater - 7.3L Diesel: Removal

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  2. Release the retaining clip and disconnect the electrical connector from the block heater.
    Fig 1: Releasing Retaining Clip And Disconnecting Electrical Connector From Block Heater
    G01537991Courtesy of FORD MOTOR CO.
  3. Loosen and remove block heater unit from the engine oil cooler.
    Fig 2: Removing Block Heater Unit From Engine Oil Cooler
    G01537992Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals