Disassembly and Assembly

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Do not clamp the driveshaft in the jaws of a vice or a similar holding fixture.

Place the driveshaft on a suitable workbench.
On reverse slip driveshafts, while using a suitable flange holding tool to prevent shaft rotation, remove the flange retaining nut.

Fig 1: Removing Flange Retaining Nut
Courtesy of FORD MOTOR CO.
On reverse slip driveshafts, remove the flange.

Fig 2: Removing Flange
Courtesy of FORD MOTOR CO.
Remove the rubber insulator surrounding the bearing.
1. Remove the driveshaft center bearing retainer.
2. Remove the driveshaft center bearing bracket.
3. Remove the rubber insulator.
Fig 3: Removing Rubber Insulator Surrounding Bearing
Courtesy of FORD MOTOR CO.
Using a suitable press, remove the bearing from the driveshaft.

Fig 4: Removing Bearing From Driveshaft
Courtesy of FORD MOTOR CO.
Using a suitable press, remove the dust slinger.

Fig 5: Removing Dust Slinger
Courtesy of FORD MOTOR CO.

NOTE: Clean grease deposits, dirt and rust from the stub shaft.

NOTE: Inspect the stub shaft splines for nicks, gouges, or burrs. Remove with a file or emery cloth

NOTE: The driveshaft center bearing bracket must be installed with the deep flange rearward

To assemble, reverse the disassembly procedure.

Lubricate the stub shaft spline with grease.

Fig 6: Tightening Flange Retaining Nut

Courtesy of FORD MOTOR CO.