LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 308 (Transfer Case) >> In-Vehicle Repair >> Transfer Case Rear Output Shaft Flange Dust Shield >> Installation

Transfer Case Rear Output Shaft Flange Dust Shield: Installation

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the special tool, install the companion flange dust shield.
    Fig 1: Installing Companion Flange Dust Shield Using Special Tool
    G02051492Courtesy of FORD MOTOR CO.
  2. Install the companion flange. Refer to TRANSFER CASE REAR OUTPUT SHAFT FLANGE .
    3. NOTE: Refill capacities are determined by filling the transfer case to the bottom of the filler hole.
  3. Check the transfer case oil level. Refer to TRANSFER CASE DRAINING AND FILLING .
scientia non olet · About LEMON Manuals