LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 308 (Transfer Case) >> In-Vehicle Repair >> Transfer Case Driven Gear Seal >> Installation

Transfer Case Driven Gear Seal: Installation

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Clean the inside of the driven gear of foreign material prior to installation.
    Fig 1: Installing Driven Gear Seal Using Special Tools
    G02051496Courtesy of FORD MOTOR CO.
  1. Using the special tools, install the driven gear seal.
  2. Install the transfer case. Refer to TRANSFER CASE-3.0L (4V) .
  3. Fill the transfer case. Refer to TRANSFER CASE DRAINING AND FILLING .
  4. Check the transaxle fluid level. Refer to CHECKING FLUID LEVEL .
scientia non olet · About LEMON Manuals