LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 306 (Manual Transmission) >> In-Vehicle Repair >> Vehicle Speed Sensor (VSS)-4x4 >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the vehicle speed sensor (VSS) electrical connector.
    Fig 1: Disconnecting Vehicle Speed Sensor (VSS) Electrical Connector
    G02051161Courtesy of FORD MOTOR CO.
  2. Raise the vehicle on the hoist.
  3. Remove the bolt and the VSS.
    Fig 2: Removing VSS
    G02051162Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals