LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 303 (Overhaul - Automatic Transmission) >> In-Vehicle Repair >> Output Shaft Speed (OSS) Sensor >> Installation

Output Shaft Speed (OSS) Sensor: Installation

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect and lubricate O-ring with petroleum jelly.
    1. Install the OSS sensor into the transmission.
    2. Tighten OSS sensor screw.
    Fig 1: Installing OSS Sensor
    G02152448Courtesy of FORD MOTOR CO.
  2. Connect OSS sensor electrical connector.
    Fig 2: Connecting OSS Sensor Electrical Connector
    G02152449Courtesy of FORD MOTOR CO.
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals