LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 303 (Overhaul - Automatic Transmission) >> Disassembly & Assembly Of Subassemblies >> Output Shaft Ring Gear & Hub Shaft Assembly >> Disassembly

Output Shaft Ring Gear & Hub Shaft Assembly: Disassembly

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Output Shaft Ring Gear & Hub Shaft Assembly Components
G02152970Courtesy of FORD MOTOR CO.
  1. Inspect the output shaft ring gear, output shaft hub, needle bearing (10B), and needle bearing race (10A) assembly for damage. If service is required use the following procedure.
  2. Remove the No. 10B needle bearing.
    Fig 2: Removing Needle Bearing
    G02152971Courtesy of FORD MOTOR CO.
  3. Remove the No. 10A needle bearing race assembly.
    Fig 3: Removing Needle Bearing Race Assembly
    G02152972Courtesy of FORD MOTOR CO.
  4. Remove the output shaft hub from the output shaft ring gear.
    1. Remove the retaining ring.
    2. Remove the output shaft hub.
    Fig 4: Removing Output Shaft Hub From Output Shaft Ring Gear
    G02152973Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals