Removal And Installation: Bushing-Carrier: Removal

WARNING: This page is about a different car, the 2002 Ford Pickup, 2001 Ford Pickup, and 2000 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: It is not necessary to remove the axle assembly from the jack.

Remove the front drive axle assembly. Refer to AXLE ASSEMBLY-Front Drive .
Position the carrier bushing removal tools.
1. Position the Bushing Cup Remover/Replacer.
2. Position the Drawbolt through Bushing Cup Remover/Replacer and the bushing.
3. Thread the Bushing Remover on the Drawbolt.
  
  Fig 1: Positioning Carrier Bushing Removal Tools
  Courtesy of FORD MOTOR CO.
Tighten the Drawbolt to remove the carrier bushing.

Fig 2: Tightening Drawbolt To Remove Carrier Bushing
Courtesy of FORD MOTOR CO.