LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 282 (Rear Drive Axle/Differential - Ford 7.5-Inch Ring Gear) >> In-Vehicle Repair >> Rear Wheel Bearing and Axle Shaft Oil Seal >> Removal

Rear Wheel Bearing and Axle Shaft Oil Seal: Removal

WARNING: This page is about a different car, the 2003 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the axle shaft. For additional information, refer to AXLE SHAFT .
    2. NOTE: If the wheel bearing oil seal is leaking, the axle housing vent may be plugged.
    Fig 1: Removing Rear Wheel Bearing & Wheel Bearing Oil Seal
    G01291273Courtesy of FORD MOTOR CO.
  2. Using the special tools, remove the rear wheel bearing and wheel bearing oil seal.
scientia non olet · About LEMON Manuals