LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 282 (Rear Drive Axle/Differential - Ford 7.5-Inch Ring Gear) >> In-Vehicle Repair >> Drive Pinion Seal >> Installation

Drive Pinion Seal: Installation

WARNING: This page is about a different car, the 2003 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new rear axle drive pinion seal with grease.
  2. Using the special tool, install the rear axle drive pinion seal.
    CAUTION: If the rear axle drive pinion seal becomes misaligned during installation, remove the rear axle drive pinion seal and install a new seal.
    Fig 1: Installing Rear Axle Drive Pinion Seal
    G01291294Courtesy of FORD MOTOR CO.
  3. Install the pinion flange. For additional information, refer to DRIVE PINION FLANGE .
scientia non olet · About LEMON Manuals