LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2790 (Engine Controls - Powertrain DTC Charts & Descriptions - DTC P0600 Through DTC P164A - (Except Diesel & Hybrid)) >> DTC P0689: Electronic Control Module (ECM)/Powertrain Control Module (Pcm) Power Relay Sense Circuit Low

DTC P0689: Electronic Control Module (ECM)/Powertrain Control Module (Pcm) Power Relay Sense Circuit Low

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.
P0689 - ELECTRONIC CONTROL MODULE (ECM)/POWERTRAIN CONTROL MODULE (PCM) POWER RELAY SENSE CIRCUIT LOW

Description:  The PCM monitors the voltage on the ignition switch position run (ISP-R) and the fuel injector power monitor (INJPWRM) circuits. This DTC sets when the voltage on the ISP-R and the INJPWRM circuit voltages do not correspond for a calibrated period of time.
Possible Causes: 
  • Ignition circuit fuse
  • ISP-R circuit open in the harness
  • ISP-R circuit short to ground in the harness
  • Fuel injector voltage power (VPWR) circuit short to voltage
  • Fuel injector power monitor (INJPWR) circuit short to voltage
  • Damaged ignition switch
  • Damaged fuel pump relay
  • Damaged PCM power relay
Diagnostic Aids:  The INJPWRM PID voltage reading should be 0 volts when the ignition is in the OFF, ACC or LOCK position.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST B .