DTC P0453: Evaporative Emission System Pressure Sensor/Switch High
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.
P0453 - EVAPORATIVE EMISSION SYSTEM PRESSURE SENSOR/SWITCH HIGH
| For Vehicles With NVLD Module | |||
| Description: | The natural vacuum leak detection (NVLD) module monitors the position of the NVLD module pressure switch. This DTC sets if the NVLD module pressure switch voltage is out of range high. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | |||
| For All Others | |||
| Description: | The powertrain control module (PCM) monitors the evaporative emission (EVAP) control system fuel tank pressure (FTP) sensor input signal to the PCM. The test fails when the signal average jumps above a minimum allowable calibrated parameter. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | An FTP voltage PID reading greater than 4.85 volts with the ignition ON, engine OFF or with the ignition ON, engine running, indicates a concern is present. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| Fiesta | GO to PINPOINT TEST HZ . | ||
| All others | GO to PINPOINT TEST HX . | ||