LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2788 (Engine Controls - Powertrain DTC Charts & Descriptions - DTC P0001 Through DTC P0217 - (Except Diesel & Hybrid)) >> DTC P0171: System Too Lean (Bank 1)

DTC P0171: System Too Lean (Bank 1)

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.
P0171 - SYSTEM TOO LEAN (BANK 1)

Description:  The adaptive fuel strategy continuously monitors the fuel delivery hardware. The test fails when the adaptive fuel tables reach a rich calibrated limit. Refer to POWERTRAIN CONTROL SOFTWARE , Fuel Trim for additional information.
Possible Causes:  Fuel System:
  • Ethanol content in the fuel
  • Fuel filter plugged or dirty
  • Damaged or worn fuel pump
  • Leaking fuel pump check valve
  • Leaking or contaminated fuel injectors
  • Low fuel pressure or running out of fuel
  • Evaporative emission (EVAP) canister purge valve is leaking when the canister is clean
  • Fuel supply line restricted
  • Fuel rail pressure (FRP) sensor bias

Exhaust System:
  • Exhaust leaks in the exhaust manifold gasket or mating gaskets before or near the heated oxygen sensor (HO2S)

EGR System:
  • Vacuum hose disconnected on exhaust gas recirculation (EGR) system module (ESM) applications
  • EGR valve tube or gasket leak
  • EGR vacuum regulator solenoid leak

Intake Air System:
  • Air leaks after the mass airflow (MAF) sensor
  • Vacuum leaks
  • Positive crankcase ventilation (PCV) system is leaking or the valve is stuck open
  • Incorrectly seated engine oil dipstick
  • Intake air turbulence due to incorrect air filter
  • Damaged or contaminated MAF sensor
Diagnostic Aids:  View the freeze frame data to determine the operating conditions when the DTC was set. Observe the LONGFT1 and LONGFT2 PIDs. Refer to ADAPTIVE FUEL DIAGNOSTIC TROUBLE CODE (DTC) DIAGNOSTIC TECHNIQUES , for additional information and the appropriate pinpoint test for specific concern identification.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST H .