DTC P016A: O2 Sensor Not Ready (Bank 1, Sensor 1)
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.
P016A - O2 SENSOR NOT READY (BANK 1, SENSOR 1)
| Description: | The heated oxygen sensor (HO2S) monitor tracks the rate of voltage change during the rise and fall of the HO2S signal. When the rate of voltage change is less than a calibrated value, the powertrain control module (PCM) begins to modify the fuel trim attempting to increase the HO2S voltage switch rate. This DTC sets when the PCM is at the allowable limit or has exceeded an allowable length of time for fuel trim modification, without detecting an acceptable rate of voltage change. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Access the HO2S test results from the scan tool to verify the DTC. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST DW . | ||