PCM Reset Procedure
WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2002 Lincoln Town Car, 2002 Lincoln Navigator, 2002 Lincoln LS, 2002 Lincoln Continental, and 2002 Lincoln Blackwood. However, it is still accessible from the selected car via links, so may be relevant.
After a PCM reset procedure has been performed, the following conditions will be met:
- All DTCs will be cleared from PCM memory.
- All freeze frame data will be cleared from PCM memory.
- Diagnostic monitoring results will be cleared from PCM memory.
- OBD-II system monitor status will reset.
- DTC P1000 will be set in PCM memory until all OBD-II system monitors or components have been tested to satisfy OBD-II drive cycle without any faults occurring. To clear DTC P1000, perform DRIVE CYCLE PROCEDURE under DIAGNOSTIC MONITORS. Ensure OBD-II DRIVE CYCLE PROCEDURE is performed to verify repair.
To perform PCM reset using scan tool, follow scan tool manufacturer's operating instructions. If after clearing DTCs a concern has not been corrected, or a fault is still present, a hard code will immediately be reset in PCM memory.