LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2780 (Engine Controls - System Test JE Through Z - CNG, Flex-Fuel & Gasoline) >> Test TJ: Output Shaft Speed Sensor >> Diagnostic Aids

Diagnostic Aids

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2003 Mercury Sable, 2003 Mercury Mountaineer, 2003 Mercury Marauder, 2003 Mercury Grand Marquis, and 2003 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

Perform this test when instructed during QUICK TEST or if directed by other test procedures. This test is used to diagnose the following:

Fig 1: Identifying Output Shaft Speed Sensor Circuits & Harness Connector Terminals (Aviator, Explorer, LS, Mountaineer, Ranger & Thunderbird)
G00191015Courtesy of FORD MOTOR CO.
Fig 2: Identifying Output Shaft Speed Sensor Circuits & Harness Connector Terminals (Econoline, Expedition, Explorer, Mustang & Pickup - With 4R70W A/T)
G00191013Courtesy of FORD MOTOR CO.
Fig 3: Identifying Output Shaft Speed Sensor Circuits & Harness Connector Terminals (Escape & Windstar)
G00191014Courtesy of FORD MOTOR CO.
Fig 4: Identifying Output Shaft Speed Sensor Circuits & Harness Connector Terminals (Focus 2.0L A/T)
G00014377Courtesy of FORD MOTOR CO.
Fig 5: Identifying Output Shaft Speed Sensor Circuits & Harness Connector Terminals (Focus 2.0L M/T)
G00014375Courtesy of FORD MOTOR CO.
Fig 6: Identifying Output Shaft Speed Sensor Circuits & Harness Connector Terminals (All Others)
G99H02663Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals