LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2761 (Engine Controls - Pinpoint Test DY: Engine Oil Temperature (EOT) Sensor Through Pinpoint Test Hf: Catalyst Efficiency Monitor And Exhaust Systems - (Except Diesel & Hybrid)) >> Pinpoint Test FB: Power Take Off (PTO) >> Test Procedure

Test Procedure

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2005 Mercury Sable, 2005 Mercury Mountaineer, 2005 Mercury Monterey, 2005 Mercury Montego, and 2005 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
  1. FB1 PTO NOT WORKING CORRECTLY: CHECK THE PTO INDICATOR LAMP OPERATION 
    NOTE: The following conditions must be met before the PTO will engage:
    • Engine at normal operating temperature.
    • Accelerator pedal is released.
    • TFT within normal operating temperature.
    • Parking brake is applied.
    • Brake pedal is released.
    • Automatic transmission is in the PARK position.
    • Manual transmission - the clutch pedal is released.
    NOTE: This step requires operating the PTO component. Refer to the aftermarket manufacturer for the PTO operating instructions. Follow all safety precautions.
    • Key on engine running.
    • Activate the PTO switch.

    Does the PTO light illuminate? 

    Yes No
    GO to the aftermarket PTO mechanical manual. GO to  FB2.
  2. FB2 CHECK THE INTEGRITY OF THE PTO SWITCH AND THE PTO SWITCH CIRCUIT 
    • Access the PCM and monitor the PTO PID.
    • Cycle the PTO switch. From off to on to off.

    Does the PTO PID change state? 

    Yes No
    GO to  FB3. REPAIR the PTO circuit or switch as necessary
  3. FB3 CHECK THE PTO LOAD PID STATE IN THE PCM 
    • Access the PCM and monitor the PTO LOAD PID.
    • Cycle the PTO switch.

    Does the PTO LOAD PID change state? 

    Yes No
    GO to  FB4. REPAIR the PTO ENG circuit or switch as necessary.
  4. FB4 CHECK THE PTOIR_V PID STATE IN THE PCM 
    • Access the PCM and monitor the PTOIR_V PID.
    • Cycle the PTO switch.

    Does the PTOIR_V PID change state? 

    Yes No
    GO to  FB5. REPAIR the PTO RPM circuit or switch as necessary.
  5. FB5 CHECK THE PTOIL PID STATE IN THE PCM 
    • Access the PCM and monitor the PTOIL PID.
    • Cycle the PTO switch.

    Does the PTOIL PID change state? 

    Yes No
    GO to  FB6. VERIFY no DTCs are present. VERIFY the vehicle conditions in step FB1 are correct for PTO operation.
  6. FB6 PTO INDICATOR LAMP ALWAYS OFF OR ON: CHECK THE PTOIL_F PID 
    • Access the PCM and monitor the PTOIL_F PID.

    Is a fault present? 

    Yes No
    Key in OFF position. REPAIR the circuit as necessary. Key in OFF position.
    GO to the aftermarket PTO mechanical manual.
scientia non olet · About LEMON Manuals